Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Operation
de
Preparation
Keep the packaging material for later safe storage or
en
transport.
fr
f Check that the contents are complete.
f Check all the parts for possible transport damage.
it
Safety
Handle with care! Damage due to incorrect power
es
supply.
f Only operate the appliance with an alternating cur-
rent and with the voltage stated on the nameplate.
pt
Charging the battery
nl
Before the appliance is used for the first time, it
should be charged for approx. 2 hours!
sv
1. Connect the appliance plug (J) on the plug-in transformer to
the appliance socket (D) (Fig. 2).
no
2. Insert the plug-in transformer into the mains socket.
3. Switch off the appliance using the on/off switch (Fig. 3ⓑ).
fi
·
During charging, the charging indicator (C) flashes
at evenly spaced intervals. When the battery is
tr
fully charged, the charging indicator flashes at a
different rate (16 on / 1 off).
·
It should take around 2 hours for the appliance to
pl
charge to full capacity.
cs
Battery operation
1. Switch on the appliance using the on/off switch and switch
sk
off after use (Fig. 3ⓐ/ⓑ).
·
When the battery is fully charged, the appliance
hr
can be used for up to 100 minutes without mains
connection. This capacity is attained after approx.
5 - 10 charging cycles.
hu
·
In case of insufficient maintenance of the
blade set, the operating time can be reduced
sl
considerably.
Mains operation
ro
1. Connect the appliance plug (J) on the plug-in transformer to
the appliance socket (D) (Fig. 2).
bg
2. Insert the plug-in transformer into the mains socket.
3. Switch on the appliance using the on/off switch and switch
ru
off after use (Fig. 3ⓐ/ⓑ).
uk
el
ar
12
Operation
Cutting with the attachment combs
The appliance can also be operated with attachment combs.
The following attachment combs are included as standard:
·
Attachment comb small = cutting lengths 3 mm and 6 mm
·
Attachment comb large = cutting lengths 9 mm and 12 mm
·
The cutting length (in mm) is shown on the attach-
ment comb.
·
One attachment comb can be used for two differ-
ent cutting lengths. For the second cutting length,
all you need to do is remove the attachment
comb, rotate and replace.
·
The advantage of these attachment combs is that
no matter the angle at which you approach the
hair, you always achieve the same cutting length.
Attaching/removing the attachment comb
1. Place the attachment comb onto the cutting edge of the
blade set and press it down onto the blade set into the
knobs in the direction of the housing until it clicks into posi-
tion (Fig. 4ⓐ).
2. The attachment comb can be removed by pushing it in
towards the cutting edge (Fig. 4ⓑ).
Maintenance
Cleaning and care
Warning! Injuries and material damage due to
incorrect handling.
f Switch off the appliance before cleaning it or per-
forming any maintenance and disconnect it from
the mains.
Danger! Electric shock due to penetration of
liquid.
f Do not immerse the appliance in water!
f Do not allow any liquid to get inside the appliance.
f Only reconnect the appliance to the power supply
if it is completely dry.
Handle with care! Danger from aggressive
chemicals.
Aggressive chemicals could damage the appliance
and accessories.
f Never use solvents or scouring agents.
f Only use cleaning agents and blade set oil recom-
mended by the manufacturer.
Accessories and spare parts are available from your
dealer or our service centre.
Publicité
Table des Matières
