Reprogramming If A Transmitter Is Damaged Or Lost; Resetting To The Delivery Status - Selve SE Plus-R Notice D'utilisation

GB Functions in service mode

8.2. Reprogramming if a transmitter is damaged or lost

Only use if a programmed transmitter is no longer available (damaged or lost)!
In order to program a new transmitter/channel, the receiver has to be put into repro-
gramming mode by disconnecting it from the mains supply. Subsequently press the
PROG button of the new transmitter for 3 sec. All the old transmitters/channels have
been depro grammed.
Fuse/Hirschmann plug
3 sec. 3 sec. 3 sec.

8.3. Resetting to the delivery status

In the state of delivery, no end positions and no transmitters are taught in the drive!
To return the drive to the state at delivery, the drive must be brought into service mode
by disconnecting it. Then press the PROG button of an assigned transmitter for
9 seconds.
Fuse/Hirschmann plug
3 sec. 3 sec. 3 sec.
new transmitter
➡
assigned transmitter
➡
38
3 sec.
9 sec.