Troubleshooting; Before Calling For Service - LG A90 Série Manuel Du Propriétaire

us_main.book.book Page 24 Tuesday, December 15, 2020 3:58 PM

24 TROUBLESHOOTING

TROUBLESHOOTING

Before Calling for Service

Operation
Problem
The appliance does Battery is fully discharged.
not operate.
• Charge the battery.
Appliance is turned off.
• Press the Power button to turn on the appliance.
Suction power is too Dust bin is full of dust.
weak.
• Empty the dust bin.
Filters are clogged.
• Clean the pre-filter and the exhaust filter.
Inlet is clogged.
• Remove any foreign objects from inside the product body or the extension pipe.
Foreign object is on rotating brush, or in inlet port.
• Remove any foreign objects (thread, hair) from the rotating brush or the inlet port.
The product body Power adapter is not connected to the charging station.
does not appear to
• Plug the adapter firmly into the charging station.
be charging.
Power cord is unplugged.
• Plug the power cord securely into the charging station.
Foreign object is on the charging terminals.
• Remove dirt or foreign objects from the charging terminals with a dry cloth.
Hot air is coming Motor is cooling.
from the product
• If the appliance is running normally, the hot air is a result of the motor cooling and is not a
body.
A strange odor is Appliance was purchased within the last 3 months.
coming from the
• The cleaner may emit a smell of rubber for about 3 months after purchase.
appliance.
Dust bin is full of dust.
• The dust in the bin may cause some odor. Empty the bin and clean it.
Foreign object is on the filter.
• The filter may emit an odor if it has not been cleaned for some time. Clean the pre-filter
Pre-filter was installed while damp or wet.
• Wash the pre-filter with running water. To avoid odor, allow the pre-filter to dry completely
Exhaust filter was installed while damp or wet.
• Wash the exhaust filter with running water. To avoid odor, allow the exhaust filter to dry
The appliance makes Vacuum cleaner is running in Turbo mode.
too much noise.
• The motor may be louder at the higher suction power settings. This is normal.
sign of malfunction.
and exhaust filter regularly.
in a well-ventilated area out of direct sunlight for at least 24 hours before reassembling.
completely in a well-ventilated area out of direct sunlight for at least 24 hours before
reassembling.
Possible Cause & Solution