Table 3 Choosing Cable-Entry Devices For Equipment In - Federal Signal Global Série Consignes D'installation Et De Maintenance

Installation and Maintenance Instructions
All returns are subject to a re-stock fee.
Defective products that are returned within the warranty period will be repaired
or replaced at Federal Signal's sole discretion. Defective products do not include
those products with lamp failure.
Circumstances other than those listed above will be addressed on a case-by-
case basis.
Models
G-LED-XXX-D-X
(Ex db surface mount)
G-LED-XXX-E-X
(Ex db surface mount)
G-LED-XXX-D-X
(Ex db surface mount)
G-LED-XXX-E-X
(Ex db e surface
mount)
2645 Federal Signal Drive
University Park, IL 60484-3167
signaling.fedsig.com
Customer
Technical
26
Table 3 Choosing cable-entry devices for
Equipment in Potentially Explosive Atmospheres
Ex
Atmospheres
Gas
Gas
Dust
Support: 1
Support: 1 800-755-7621 • 1 708-587-3587
Model G-LED Global Series LED Beacon
Cable Entry Devices
(cable glands, stopping plugs, etc.)
Cable entry devices shall be equipment
certified as flameproof. To maintain the ingress
protection of the flameproof beacon enclosure,
we recommend the cable entry device be
IP66 certified.
For the flameproof beacon enclosure, cable
entry devices shall be equipment certified
as flameproof. To maintain the ingress
protection of the flameproof beacon enclosure
we recommend the cable entry device be
IP66 certified. For the increased safety
terminal enclosures (terminal boxes), cable
entry devices shall be equipment certified
as increased safety and shall maintain an
IP rating of IP54.
Cable entry devices for the Beacon and
terminal enclosures shall be equipment
certified as dust protected. To maintain the
ingress protection of the beacon and terminal
enclosures the cable entry devices shall be
IP6X certified.
800-344-4634 • 1 708-534-4756