LaserLiner MultiMeter-Compact Mode D'emploi page 19

Please ensure that the test prods are connected correctly
!
before each measurement. Taking a voltage measurement
with 10 A current connections plugged in can cause
the installed fuse to trip and result in damage to the
measuring circuit.
4
Current measurement DC/AC
To take a current measurement, turn
the rotary switch to position „10 A"
and press the „Mode" button to set
the voltage mode (AC, DC).
Disconnect the circuit before connecting
the meter. Then connect the measuring
contacts to the object to be tested.
The measured value acquired and
the polarity appear on the display.
Disconnect the circuit again before
disconnecting the meter.
!
Do not measure currents above 10 A for longer
than 30 seconds. This could damage the device
or the test prods.
5 Voltage measurement DC/AC
To take a voltage measurement, turn
the rotary switch to position „V" and
press the „Mode" button to set the
voltage mode (AC, DC). Then connect
the measuring contacts to the object to
be tested. The measured value acquired
and the polarity appear on the display.
MultiMeter-Compact
red
black
black
red
19
EN