Safety Instructions - LaserLiner MultiMeter-Compact Mode D'emploi

Completely read through the operating instructions,
the „Warranty and Additional Information" booklet as
!
well as the latest information under the internet link
at the end of these instructions. Follow the instructions
they contain. This document must be kept in a safe place
and passed on together with the device.
Function/Application
Multimeter for taking measurements in the range of the overvoltage
category CAT III up to max. 1000 V/CAT IV up to max 600 V. The
meter can be used to measure DC and AC voltages, direct and
alternating currents, resistances, capacitances, frequencies and duty
factors within the specified ranges; it can also be used for continuity
and diode testing. In addition, the meter is fitted with a non-contact
voltage detector and a vibration alarm.
Symbols
Hazardous electrical voltage warning:
Unprotected live components inside the device
housing may pose a risk of electric shock.
Danger area warning
Protection class II: The test device has reinforced
or double insulation.
Overvoltage category III: Equipment in fixed installations
and for applications where specific requirements with
regard to the reliability and availability of equipment
have to be met, e.g. circuit-breakers in fixed installations
and devices used in industrial applications which are
permanently connected to the fixed installation.
Overvoltage category IV: Devices such as electricity
meters, overcurrent circuit breakers and ripple-control
units, which are intended for use at or near the infeed
into the electrical installation of buildings, and specifically
from the main distribution to the supply system.

Safety instructions

– The device must only be used in accordance with its intended
purpose and within the scope of the specifications.
– The measuring tools and accessories are not toys.
Keep out of reach of children.
– Modifications or changes to the device are not permitted, this
will otherwise invalidate the approval and safety specifications.
14
EN