JUNO JKSN301R6 Notice D'utilisation page 26

26
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
You cannot activate the outer
ring.
There is a dark area on
the multiple zone.
The sensor fields become
hot.
comes on.
comes on.
and a number come on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
Possible cause
You touched 2 or more sen-
sor fields at the same time.
STOP+GO function operates.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
message that comes on. Make sure, you
operated the hob correctly. If not the
Remedy
Touch only one sensor field.
Refer to "Daily use" chapter.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.