Table des Matières
Publicité
8
2.3 Extension cable
If an extension cable is required, it must have a sufficient
cross-section so as to prevent an excessive drop in voltage
or overheating. An excessive drop in voltage reduces the
output and can lead to failure of the motor. The table shows
the correct size to use, depending on cord length and tool's
ampere rating. Use only U.L. and CSA listed extension cables.
Never use two extension cables together. Instead, use one
long one.
Note: The lower the A.W.G. number, the stronger the cable.
3
Machine settings
Always disconnect the plug from the power supply
before making any adjustments to the machine or installing
or removing any accessory!
3.1 Electronic control
The PS 2 E has control electronics which enable an infinite
adjustment of the number of strokes between 1200 and 3300
strokes per minute. The desired number of strokes is set with
the adjusting wheel (2.1):
setting 1 = 1 200 strokes per minute,
setting 6 = 3 300 strokes per minute.
Recommended number of strokes (adjusting wheel
setting):
Hard and soft wood, wood core plywood:
plywood, chip board:
Wood fibre boards:
Plastics:
Ceramic:
NF metals:
Steel:
3.2 Pendulum stroke
In order to process different materials with an optimum feed
movement the pendulum jigsaws have an adjustable
pendulum stroke. Select the desired setting with the pendulum
stroke switch (3.1):
setting 0 = pendulum stroke off,
setting 3 = maximum pendulum stroke.
Recommended settings of the pendulum stroke:
Hard and soft wood:
Wood core plywood, plywood:
Chip board, wood fibre board:
Plastics:
Ceramic:
Aluminium, NF metals:
Steel:
3.3 Adjusting the base runner
The base runner can be swivelled to both sides by up to 45°
for bevel cuts:
- Remove chip guard and splinterguard.
- Release locking screw (4.1) with Allen key.
- Push base runner approx. 5 mm forwards.
- Set desired inclination according to the scale (4.4).
- Tighten locking screw (4.1).
The base runner can be moved back for sawing close
to edges.
- Remove chip guard and splinterguard.
- Release locking screw (4.1) with Allen key.
- Push base runner to rear position so that the centring pin
(4.2) fits in the opening (4.3).
- Tighten locking screw (4.1).
6
6
4-6
3-6
3-5
3-5
2-4
1-3
1-2
1-3
1-2
0
0-2
0-1
Publicité
Table des Matières
