Philips StyleShaver QS6161 Mode D'emploi page 10

ENGLISH
10
5 To trim the hair, move the trimming comb through the hair slowly.
Tips
- Always make sure that the tips of the trimming comb points in the
direction in which you move the appliance.
- Make sure that the flat part of the trimming comb is always in full
contact with the skin to obtain an even hair length result.
- Since hair grows in different directions, you need to move the appliance
in different directions as well (upward, downward or across).
- You can switch on the trimming head while the shaving head is
operating. If you do this, the shaving head is switched off immediately.
- Trimming is easier when the skin and hair are dry.
6 When you are finished, press the trimming head on/off button again
to switch off the trimming head.
Trimming without comb
The comb keeps the trimming head at a set distance from your head. You
can use the trimming head without comb.If you use the trimming head
without comb, your hair is cut off close to the skin (approx. 0.5 mm).
1 To remove the comb, pull it off the appliance.
Never pull at the flexible top of the comb. Always pull at the bottom part.
2 Press the trimming head on/off button to switch on the trimming
head.
3 Hold the appliance with the trimming head pointing upwards and
make downward strokes with the regular side of the trimming head.
Using the precision side of the trimming head
The precision trimming head is only half as wide as the regular trimming
head. It therefore allows more precise styling of the area around the ears,
the sideburns and also around the mouth and under the nose.