Canarm GSQ-D Série Mode D'emploi page 3

GSQ-D SERIES
GSQ-D EC SERIES
STANDARD WIRING INSTRUCTIONS
1. A qualified electrician in accordance with all local and National Electrical Codes should do all wiring.
2. Ensure power supply is disconnected and locked out prior to making electrical connections.
3. Excess wire must be restrained in order to prevent it from entering the pulley, shaft or wheel rotating area.
4. Disconnect switches are recommended and should be located near the fan in order to, swiftly cut off power in case of an emergency
and maintain complete control of the power source.
5. Follow the wiring diagram on the motor nameplate.
EC (ELECTRONICALLY CONTROLLED) MOTOR SPEED CONTROL
EC motors are equipped with a control module that allows for accurate manual
adjustment of motor speed. Motor speed range is from 300 to 1800 rpm or maximum
rpm for that model.
The control module features a 4 digit LED display that indicates % demand of full
speed and motor speed in rpm. The display also indicates an error code message
for minor diagnostics if required.
MESSAGE DISPLAYED
Spd- followed by the instantaneous speed in rpm
dE-
followed by S + demand in %
E1-
No communications
E2- Under Voltage
Motor speed can be changed by adjusting the speed control pot located on the
control module. A small screwdriver can be used to make the speed adjustment.
AC Supply - 120/208-230VAC
Power is connected to the motor and control module through the junction box and wiring harness provided.
Note: For 115VAC operation the blue jumper provided(taped to wire harness) must be inserted into motor power connector. See diagram.
Caution: Operating the motor at 208-230VAC with the jumper will cause significant damage to the motor.
120/208-230 VAC
Note: EC motors have a soft start feature. When the power is turned on the control module gathers information from the motor then begins the start up
process. After a few seconds the motor will start to turn and reach full set speed in 10-30 seconds.
Remote Speed Control Option (please contact factory for further information)
M_GSQ_D_06_16_2022
120 VAC System
EC Motor wiring diagram
208-230 VAC System
Control
EC Motor
Module
Page 3 of 5