Breathable Air Warning; General Safety - Campbell Hausfeld CE4104 Mode D'emploi

Important Safety Information (Continued)
This compressor/pump is not equipped and should not be used "as is" to supply breathing quality
air. For any application of air for human consumption, the air compressor/pump will need to be
fitted with suitable in-line safety and alarm equipment. This additional equipment is necessary to
properly filter and purify the air to meet minimal specifications for Grade D breathing as described in
Compressed Gas Association Commodity Specification G 7.1, OSHA 29 CFR 1910. 134, and/or Canadian
Standards Associations (CSA).
DISCLAIMER OF WARRANTIES
In the event the compressor is used for the purpose of breathing air application and proper in-line
safety and alarm equipment is not simultaneously used, existing warranties shall be voided, and
Campbell Hausfeld disclaims any liability whatsoever for any loss, personal injury or damage.

General Safety

• Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the
proper use of the equipment.
MANUAL
• Follow all local electrical and safety codes as well as the United States National Electrical Codes (NEC)
and Occupational Safety and Health Act (OSHA).
• Only persons well acquainted with these rules of safe operation should be allowed to use the
compressor.
• Keep visitors away and NEVER allow children in the work area.
• Wear safety glasses and use hearing protection when operating the unit.
• Do not stand on or use the unit as a handhold.
• Before each use, inspect compressed air system and electrical components for signs of damage,
deterioration, weakness or leakage. Repair or replace defective items before using.
• Check all fasteners at frequent intervals for proper tightness.
flammable liquids or gases in the vicinity of the compressor.
• Do not wear loose clothing or jewelry that will get caught in the moving parts of the unit.
• Keep fingers away from a running compressor; fast moving and hot parts will cause injury and/or burns.
• If the equipment should start to vibrate abnormally, STOP the engine/motor and check immediately for
the cause. Vibration is generally an indication of trouble.
• To reduce fire hazard, keep engine/motor exterior free of oil, solvent, or excessive grease.
this compressor. The ASME safety valve must have sufficient flow and pressure ratings to protect the pressurized
components from bursting. The flow rating can be found in the parts manual. The safety valve in the intercooler does
not provide system protection.
• Never attempt to adjust ASME safety valve. Keep safety valve free from paint and other accumulations.

BREATHABLE AIR WARNING

Motors, electrical equipment and controls can cause electrical arcs that will ignite a flammable
gas or vapor. Never operate or repair in or near a flammable gas or vapor. Never store
Never operate compressor without a beltguard. This unit can start automatically without
warning. Personal injury or property damage could occur from contact with moving parts.
Compressor parts may be hot even if the unit is stopped.
An ASME code safety relief valve with a setting no higher than the Maximum Allowable
Working Pressure (MAWP) of the tank MUST be installed in the air lines or in the tank for
Maximum operating pressure is 140 psi for single stage compressors. Do not operate with
pressure switch or pilot valves set higher than 140 psi (single stage).
3