Microphone Technique - AKG WMS40 SO 40 Mode D'emploi

2. Use a small screwdriver to turn the
input gain control (4) on the trans-
mitter to a position halfway between
the left and right stops.
3. Set the ON/MUTE/OFF switch (1) to
ON to switch power to the transmitter
on.
4. Switch power to your sound system
or amplifier on.
5. Speak or sing into the microphone.
6. If your voice sounds distorted on the
loudspeakers turn the input gain con-
trol (4) down CCW to the point that
you will hear no more distortion.
If your voice sounds too quiet on the
loudspeakers, turn the input gain
control (4) up CW. If the loudspeakers
start howling due to acoustic feed-
back, immediately turn the input gain
control (4) back down to the point
that the howling will stop.

4.4 Microphone Technique

For detailed hints on how to use a vocal
microphone, particularly with regard to
working distance, proximity effect, and
feedback, refer to the instruction manual
of your AKG microphone.
4.5 Troubleshooting
For troubleshooting hints, refer to your
receiver manual.
5 Cleaning
To clean the transmitter case,
use a soft cloth moistened with
water.
13