Using Pulse Function; Crush Ice Cubes; Cleaning; Clean Drive Unit - Exquisit MU 3001 we Instructions

17.4 Using pulse function

The blender has a pulse function.
It means short operation at full
power. By using the pulse
function is the maximum speed is
immediately available.
Use the pulse function if you
want to mix for a short time but
intense. For example, for foaming
a liquid, or for crushing ice (see

"Crush ice cubes").

In order to enable this feature,
1. Turn the speed control 6 to
the pulse level "P" and hold it
in this position for as long as
you want to mix. Use this
function only sporadically and
never exceed the maximum
operating time.
2. Stop the mixing process by
releasing the speed control.
17.5 Crush ice cubes
1. Fill ice cubes into the blender
jug 3. Do not crush more than
10 to 12 ice cubes per mixing
process. Make sure that the
ice is not greater than 2.5 cm
edge length. With a small
amount of ice cubes you get
the best results.
2. Close the mixing bowl with the
safety cover 2 and the lid
insert 1 (see section
"Compose blender").
3. Set the speed control 6 to
level "0".
4. Connect the blender to a
properly installed socket.
5. Turn the speed control several
times for a short time to the
pulse level "P" and let it go
again.
6. To end the crushing operation,
set the speed control to level
"0".
7. Unplug the blender from the
socket.

18 Cleaning

WARNING
Improper handling of the blender
can be cause an electric shock.
Water penetrated in the housing
can cause a short circuit.
Turn the blender off, and remove
the power plug from the socket
before cleaning the blender.
Make sure that no water gets into
the housing of the drive unit.
Never immerse the blender in
water.
Improper handling of the blender
can lead to damage. Do not place
the blender or individual parts in
the dishwasher.
Do not use abrasive cleaners or
scouring agents, sharp or
metallic cleaning objects such as
knives and the like. These can
damage the surface.

18.1 Clean drive unit

1. Unplug the power plug
before cleaning.
2. Allow to cool the blender
entirely.
3. Wipe the drive unit 7 with a
dry, possibly slightly damp
cloth.
4. Rub the drive unit then dry.
Use a soft cloth for this.
EN
page | 27