Initial Start-Up; Check Blender And Delivery; Basic Cleaning; Set Up Blender - Exquisit MU 3001 we Instructions

EN

16 Initial start-up

16.1 Check blender and delivery

If you open the package
carelessly with a sharp knife or
other pointed object, the blender
can be easily damaged.
Be very careful when opening.
The blender is protected from
damage during transport by the
packaging.
1. Take the blender from the
packaging.
2. Check that the blender or the
installation parts have
damage.
3. If this is the case, do not use
the blender. Contact our
specified service centre.
4. Check whether the delivery is
complete.

16.2 Basic cleaning

1. Remove the packaging
materials, and protective
films.
2. Clean all the parts of the
blenderd before the first use
as described in "Cleaning".

16.3 Set up blender

WARNING
• If you place the blender
improperly, it can cause
damage.
• Place the blender on a flat, dry
and non-slip work surface. The
work area should be easy to
clean, since you can not
always prevent splatter.
page | 24
Don't place the blender on or
near the edge of the working
surface.
Never place the blender on or
near hot surfaces (eg. hobs,
heating pipes, etc.).
Note that the surface coatings of
furnitures sometimes contain
chemical additives which affect
and soften the suction cups of
the blender. In this way, residues
can arise on the furniture
surfaces. Therefore place a non-
slip surface under the blender.
The drive unit 5 is equipped with
suction cups which provide a
secure grip for the blender.
Set the blender up that it is easy
accessible and near a power
outlet.

16.4 Compose blender

Improper handling of the blender
or individual instruments can
cause serious injury.
Turn the blender off, and remove
the plug from the socket when
you assemble or disassemble the
blender.
The blender has two safety
devices. It can only be used with
a properly attached mixing bowl
and properly attached safety
covers.
The mixing container 3 is marked
at the lower end with a triangle.
On the drive unit 7 is an open
and a closed lock illustrated.
1. Place the jug on the drive unit
so that the triangle on the jug
points to the open lock.
2. Turn the jug clockwise until
the triangle points to the
closed lock. Hold the drive
unit. It will be heard and felt
when the mixing bowl locks.
3. Place the safety cover 2 on