Fan Mode Indicators - Haiku K3150-S1 Guide D'installation

OPERATION (CONT.)
Reversing the direction of rotation
Haiku reduces heating costs in the winter by pushing warm air at the ceiling level down to floor level.
Because of the aerodynamic design of Haiku's airfoils, this is done most efficiently by operating the
fan in the forward direction (counterclockwise when viewed from the floor) with the speed at the
slowest setting so that you do not feel a draft from the fan. If, at the slowest speed setting, a draft is still
felt, the fan can be operated in the reverse direction to eliminate the draft.
To reverse the direction of rotation, press the On/Off button to turn off the fan. When the fan is at a
complete stop, press the Whoosh button on the remote control three (3) times, and then press the On/
Off button. Repeat to return the fan to forward operation.

Fan mode indicators

Each operating mode is indicated by a pattern on the fan mode indicator display, which is located on
the bottom of the fan and is visible from the floor. The display includes an LED (light emitting diode)
bar graph to indicate fan speed and Whoosh mode, and separate LEDs to indicate Timer mode and
Sleep mode.
All indicators automatically turn off approximately one minute after the last button is pressed to
minimize power consumption and prevent nuisance lighting at night. The indicators will display the
current speed setting by default.
The indicators can be reactivated by pressing any button on the remote control except the On/Off button. This
tip!
will not change the current operating setting.
Speed indicators
When the fan is running, the Speed indicator LEDs show the current fan speed (1–6). Whoosh mode
is indicated when the highest set speed indicator is flashing. When all indicators are simultaneously
flashing, Timer mode is active. Note: The controller shows seven speed indicators; however, only six
are active on the fan.
You can toggle the display from Speed mode to Timer mode by pressing the Timer button once. To
toggle from the Timer mode to Speed mode, simultaneously press the Speed button and Whoosh
button once. See the previous page for instructions on changing fan speed.
Sleep mode indicator
The Sleep LED indicates that Sleep mode is active. A flashing Sleep LED indicates that the Timer
mode is being adjusted. See the previous page for instructions on using Sleep mode.
Timer mode indicator
The Timer LED indicates that Timer mode is active. A flashing Timer LED indicates that the Timer
mode is being adjusted. See the previous page for instructions on using Timer mode.
12
6 sleep
5
4
3
2
timer
1
©2012 DELTA T CORP. ALL RIGHTS RESERVED.