1.3) Deleting The I-R Light Sensor From The Receiver - Selve i-R Light Sensor Notice D'utilisation

Transmitter programming procedure

1.3) Deleting the i-R Light Sensor from the receiver

For this process, at least two transmitters have to already be
learnt into the receiver.
Note: Deprogramming mode is ended either using a control
command from a transmitter that has been deleted or as a result
of successful deprogramming.
To delete the i-R Light Sensor, press the PROG button
of the transmitter not to be deletet for 3 seconds (wait
until the control light flashes once). Deprogramming
mode is indicated by a brief upwards and downwards movement
of the drive. Then the receiver will be in deprogramming mode
for 1 minute.
Then press the PROG button of the transmitter i-R Light
Sensor to be deleted for a short time. The transmitter
has now been deleted from the receiver.
33
GB