Package Contents; Hardware Overview - D-Link DGS-1026MP Guide De Démarrage

Before You Begin
This Quick Installation Guide gives you step-by-
step instructions for setting up your DGS-1026MP
26-Port Unmanaged Gigabit PoE Switch. The model
you have purchased may appear slightly different
from the one shown in the illustrations. For more
detailed information about the switch, please refer
to the User Manual.

Package Contents

This DGS-1026MP package should include the
following items:
• DGS-1026MP
26-Port Unmanaged Gigabit PoE Switch
• Power cord
• Power cord retainer
• Rack mount kit and rubber feet
• This Quick Installation Guide
If any of the above items are damaged or missing,
please contact your local D-Link reseller.

Hardware Overview

LED Indicators
1 2 3
2
4 5
Figure 1
# LED Status
(LED above "300W") The total PoE power
Solid red
consumption is between 301 and 370 W.
Solid (LED below "300W") The total PoE power
amber consumption is between 201 and 300 W.
PoE
Solid (LED below "200W") The total PoE power
1 Power
green consumption is between 101 and 200 W.
Budget
Solid (LED below "100W") The total PoE power
green consumption is between 1 and 100 W.
There are no PoE-powered devices
Off
connected to the switch.
The port LEDs are displaying the port
Solid
link status. See Link/Act below for more
green
information.
LED
2
Mode
The port LEDs are displaying the PoE
Solid
status. See PoE Mode below for more
amber
information.
Solid The device is powered on.
green
3 Power
Off The device is powered off.
There is an active link on the
Solid
corresponding port operating at 10/100
amber
Mbps.
Blinking There is traffic on the corresponding port
Link/Act
amber at 10/100 Mbps.
Ports 1
4
There is an active link on the
~ 26
Solid
corresponding port operating at 1000
green
Mbps.
Blinking There is traffic on the corresponding port
green at 1000 Mbps.
The PoE power supply on the
Solid
PoE
corresponding port has failed.
amber
Mode
5
Ports
Solid The corresponding port is supplying PoE
1 ~ 24
green power correctly.
Table 1
Front Panel Connectors
1
Figure 2
# Item
Press to change the port LEDs to display the
PoE status or the link status. The color of the
1 LED Mode
LED Mode light will indicate which LED status
display is currently active.
10/100/1000 Mbps PoE-capable ports for
connecting Ethernet devices and PoE-
Ports 1 ~ 24
2
powered devices.
10/100/1000 Mbps/SFP combo ports. When
using one interface of these combination
ports, the other port in the pair will become
Ports 25 ~ 26
3
unavailable. For example, using the SFP
interface on port 25 will render the RJ45
interface on port 25 unavailable.
Table 2
Description
2 3
Description