Napoleon Fireplaces BL36NTE Instructions D'installation Et D'opération page 42

42
EN
NOTE: The battery holder was supplied with your appliance but not connected. In an event of a power
This appliance comes equipped with a battery back-up. If this back-up is used, install 4AA batteries (not
failure, install four 'AA' batteries in the holder and attach to wire harness as illustrated above.
supplied) into the holder and connect to the wire harness.
TRANSFORMER
BATTERY
HOUSING
(SUPPLIED IN
MANUAL BAGGIE)
DC SUPPLY
W415-1442 / D / 12.01.16
!
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
IPI / CPI
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH AND
CONNECT TO AN
OPTIONAL THERMOSTAT.
WARNING
VALVE
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
IPI BOARD
DFC
69.7