Zibro Moonlighter Manuel D'utilisation page 63

1 1 1 1 b b
1 1 1 1 a a
1 1 2 2 1 1 3 3 a a
1 1 3 3 b b
NOTE: The space between the wick adjuster and the
primary air tube should be even all around.
NOTE: Make certain the top of the wick adjuster and
the top of primary air tube are the same weight. If they
uneven, the flames tend to be uneven, too.
10 Tighten the three (3) wing nuts around the wick
adjuster.
Turn the wick adjuster knob to be sure the wick moves
11
smoothly up and down.
AFTER REPLACING THE WICK, CHECK THE OPERATION
OF THE AUTOMATIC EXTINGUISHER.
Wick height should be 5 mm when wick adjuster knob
is turned fully clockwise. Be sure to check.
NOTE: If wick does not move smoothly and easily, or
wick height is not in the range of 4-6 mm, do not use
the heater. Disassemble and repeat items 6 through 11.
NOTE: If any ragged edges appear on the top of the
wick, trim them with a scissors carefully. DO NOT cut
the body of the wick.
12 Replace the inner heat chamber on the top of the
primary air tube.
Replace the heater cover on the fuel tank and secure it
13
into position with three (3) thumbscrews. Replace
batteries in the battery holder. Be sure that the outer
heat chamber is properly seated by moving the wire
heat chamber handle left and right.
Once again, check the proper operation of the
automatic extinguisher.
NOTE: Before lighting a new wick for the first time,
turn the wick to its lowest position and allow the wick
to saturate with kerosene for about thirty (30) minutes.
4
61