Assembly And Adjustment - Worx SD WX255L Mode D'emploi

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ACTION
BEFORE OPERATION
Charging the Battery
NOTE: 1. Maximize Battery Performance
Prior to initial use, the battery must be charged 5 hours to fully utilize the battery capacity.
2. When the battery is full charged, the light turns green.

ASSEMBLY AND ADJUSTMENT

Inserting and Removing the Bit Cartridge
Assembling and Removing the Screw Holder
INSTALLING AND REMOVING EXTENDABLE FLEXIBLE SHAFT (ONLY FOR
18
WX255L.2 )
Forward/Reverse/Lock
WARNING: Never change the direction of rotation when the chuck is rotating, wait until
it is stopped!
OPERATION
Selecting a Bit
Assembling screw
Tightening and Loosening Screw
Operating the On/Off Switch
WARNING: Do not operate for long periods at low speed because excess heat will be
produced internally.
LED Light Indicator
FIGURE
See Fig. A
See Fig. B,C
See Fig. D1,D2
See Fig. E1,E2
See Fig. F1,F2,F3
See Fig. G1, G2
See Fig. H1,
H2, H3
See Fig. I1, I2
See Fig. J
See Fig. J