Worx SD WX255L Mode D'emploi page 19

Automatic Spindle Locking
NOTE: When the SD Driver is out of power, this function enables the customer tightening or
loosening screws manually.
MAINTENANCE
Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
If you see some sparks flashing in the ventilation slots, this is normal and will not damage your power tool.
TROUBLE SHOOTING
Problem
Battery will not charge.
Switch cannot be pressed.
Driver stops during
driving screws.
Bit Cartridge will not
rotate when Cover slides.
Possible cause
1. Charger not plugged into
a working outlet.
2. Surrounding air
temperature is too hot or
too cold.
Forward/Reverse switch at
middle position.
Driver battery is out of
power.
The cover is not fully open.
Solution
1. Plug charger into a working outlet. Check
current by plugging in a lamp.
2. Move charger to an appropriate place which
temperature is suitable for the charger.
Make sure switch is on Forward or Reverse
rotation according to project need.
Make sure the driver is fully charged before
using it.
Make sure the Cover is fully open and past the
red line on the tool.
19