Screwdriver Safety Warnings - Worx SD WX255L Mode D'emploi

SCREWDRIVER SAFETY WARNINGS

1. Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden
wiring. Fasteners contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
GENERAL SAFETY WARNINGS FOR YOUR
BATTERY CHARGER
WARNING: This product can expose you to
chemicals including lead, phthalate or bisphenol
which are known to the State of California to cause
cancer, birth defects or other reproductive harm. Wash
your hands after use. For more information go to
www.P65Warnings.ca.gov.
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
WARNING: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
SAFETY INSTRUCTIONS FOR BATTERY
1) WARNING: Risk of fire and burns. Do not
disassemble, heat above 100°C (212°F), or
incinerate. Do not expose cells or batteries to
heat or fire. Avoid storage in direct sunlight.
13