Makita LS1013 Manuel D'instructions page 19

1
3
001558
1
3
001559
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding
stoppers as shown in the figure. Adjust the crown
molding stoppers according to the size of the
crown molding. Tighten the screws to secure the
crown molding stoppers. Refer to the table (C) for
the miter angle. Use the sub-fence R to secure the
crown molding more firmly.
2
1 3
001560
Position in
Miter angle
Fig. A
(1) Right 45°
For inside
corner
(2)
Left 45°
(3)
For outside
corner
(4) Right 45°
006365
1. Crown molding
2
stopper L
2. Crown molding
stopper R
3. Turn base
1. Crown molding
2
stopper L
2. Crown molding
stopper R
3. Turn base
1. Guide fence
2. Crown molding
4
3. Crown molding
stopper
4. Screw
Table (C)
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
1. Cutting aluminum extrusion
001561
1
2
004073
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a
cutting lubricant when cutting the aluminum
extrusion to prevent build-up of the aluminum
material on the blade.
CAUTION:
Never attempt to cut thick or round aluminum
•
extrusions. Thick aluminum extrusions may come
loose during operation and round aluminum
extrusions cannot be secured firmly with this tool.
2. Groove cutting
1
001563
A dado type cut can be made by proceeding as
follows:
Adjust the lower limit position of the blade using
the adjusting screw and the stopper arm to limit the
cutting depth of the blade. Refer to "Stopper arm"
section described previously.
After adjusting the lower limit position of the blade,
cut parallel grooves across the width of the
workpiece using a slide (push) cut as shown in the
19
1. Guide fence
1
2. Vise
2
3. Spacer block
4. Aluminum
3
extrusion
5. Spacer block
4
5
1. Aluminum
3
extrusion
2. Guide fence
3. Spacer blocks
4. Horizontal vise
(optional
accessory)
4
1. Cut grooves with
blade