Adjusting The Feet; Electrical Connection - Beko WTE 6501 B0 Mode D'emploi

2.6 Adjusting the feet

A
CAUTION:
In order to ensure that the product
operates more silently and vibration-free,
it must stand level and balanced on its feet.
Balance the machine by adjusting the feet.
Otherwise, the product may move from its place
and cause crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
WARNING:
Do not use any tools to loosen the
lock nuts. Otherwise, they will get damaged.

2.7 Electrical connection

Connect the product to a grounded outlet protected
by a 16 A fuse. Our company shall not be liable for
any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after
installation.
• If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
• Do not make connections via extension cables or
multi-plugs.
B
DANGER:
Damaged power cables must be
replaced by the Authorized Service Agents.
8 / EN
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply
connections.
3. Drain all water that has remained in the product.
4. Install transportation safety bolts in the reverse
order of removal procedure;
C
NOTE :
Never move the product without the
transportation safety bolts properly fixed in
place!
A
CAUTION:
Packaging materials are dangerous
to children. Keep packaging materials in a safe
place away from reach of the children.
Washing Machine / User's Manual