Beko WTE 6501 B0 Mode D'emploi page 19

4.16 Canceling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be canceled. End / Cancel
light will flash continuously to notify that the
programme has been canceled.
Your machine will end the programme when you
turn the Programme Selection knob; however, it
does not drain the water inside. When you select
and start a new programme, the newly selected
programme will start depending on the step the
previous programme was canceled in. For example,
it may take in additional water or continue to wash
with the water inside.
C
Depending on the step where the programme
was canceled in, you may have to put detergent
and softener again for the programme you have
selected anew.
4.17 Your machine is equipped with a
"Standby Mode"
In case of not starting any programme or waiting
without making any other operation when the
machine is turned on by On/Off button and while
it is in selection step or if no other operation is
performed approximately 2 minutes after the
programme you selected has come to an end, your
machine will automatically switch to energy saving
mode. Display brightness will decrease. In case of
rotating the Programme Selection knob or pressing
any button, lights will restore to their previous
condition. This is not a fault.
19 / EN Washing Machine / User's Manual