Programming - Perry DECRNN032 Mode D'emploi

4 - INSTALLATION
4.5) ATTACHING OR REMOVING THE CRONOTHERMOSTAT FROM ITS BASE
Attach the cable cover by inserting panel
1° slot E in the base, then fasten it to the catches
pressing lightly.
To remove the cover, use a small screwdriver to prize
F
apart each catch F
F
E
3°
In order to remove the
chronothermostat from its
wall-mounted base, grip
as shown in the diagram,
then pull outwards from
the left-hand side.
34
D into special
F by
in turn.
D
Easy Programming
All the settings can be carried out before
securing the chronothermostat to the base
on the wall; this allows you to do the
programming while being comfortably
seated.
Caution !
If the chronothermostat is programmed before it is fixed to the wall-mounted base,
it may happen that after installation the
does not correspond to the actual status of the relay.
Within 1 minute (max) of the chronothermostat being fixed to the base, the relay
will be activated according to the ON
2°
Fix the chronothermostat on
the base, taking care to
insert the contacts correctly,
then exert light pressure until
you hear the click of the
attachment hooks on the
base.
ON
indication (off or blinking) in the display
(off or blinking) indication displayed.