Environmental Protection; Declaration Of Conformity - Worx WG441E Notice Originale

Using the hose retaining clip
Attaching the garden hose to the brush
NOTE: After the garden hose is attached,
check the connection by gently pulling
upon the garden hose. It should not be
pulled off.
OPERATION
Starting
WARNING! Do not start or operate
the machine if others are in the
area! Never lift the device off the ground
during operation, as there is danger of
entanglement !
Adjusting the speed
Water supply
WARNING! Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
Cleaning
WARNING: Make sure that the
surface to be cleaned is free from
debris e.g. stones, screws etc., which
could be flung up.
12 12
Never put your hands or feet near to the
rotating brushing equipment!
Cleaning with Soft nylon bristles
Cleaning with Hard nylon bristles
Cleaning with Hard nylon joint cleaning
brush
NOTE: Make sure the joint brush is
aligned with the centre of the joint by
using the joint alignment mark.
Cleaning with Metal / hard nylon joint
cleaning brush
MAINTENANCE
Check if the tool and the brush are in good condition
before use. Replace the brush if it wears down to a
diameter of ø approx. 90 mm.
Do not immerse the tool in water. Do not spray or clean
it with water. Protect he tool against moisture. Clean the
outside of the tool with a damp cloth or soft brush. Do not
use abrasives or harsh cleaning agents.
Clean the brush in water or with a strong water jet or a
hard brush.
Repairs must be carried out by a Worx service point.
Patio-Brush
ENVIRONMENTAL
See Fig. E
PROTECTION
Waste electrical products should not be disposed
See Fig.
of with household waste. Please recycle where
F1, F2
facilities exist. Check with your Local Authority or
retailer for recycling advice.
DECLARATION OF
CONFORMITY
See Fig. G
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
On behalf of Positec declare that the product
See Fig. H
Description Battery-operated multifunctional brush
Type WG441E WG441E.9 (441 - designation of
machinery, representative of Battery-operated
multifunctional brush)
See Fig. I
Function Cleaning ground surface
Complies with the following Directives:
2006/42/EC, 2014/30/EU, 2011/65/EU&(EU)2015/863
Standards conform to
EN 60335-1, EN ISO 12100, EN 55014-1, EN 55014-2
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
See Fig. J1
See Fig. J2
See Fig. J3
2020/12/07
Allen Ding
See Fig. J4
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
EN