OLMEC J1 Manuel D'utilisation Et D'entretien page 24

Table des Matières

Publicité

RISERVATO AL PERSONALE AUTORIZZATO ALL'INSTALLAZIONE - ONLY FOR INSTALLATION-AUTHORIZED STAFF - SEULEMENT POUR LE PERSONNEL AUTORISE A L'INSTALLATION
5.085.0007
5.085.0082
1
24
10 SEGNALAZIONI ED AVVERTENZE
Rispettare le avvertenze richiamate dalle targhe, l'inosser-
vanza può causare offesa all'indennità personale.
ATTENZIONE:
Nel caso le targhette di pericolo risul-
tino illeggibili o siano state rimosse,
sostituirle immediatamente. Non utiliz-
zare il sollevatore se mancante di una
o più targhette di pericolo.
Non interporre oggetti che ne ostrui-
scano la visione all'operatore.
Per eventuali richieste utilizzare il co-
dice indicato nella presente tavola.
11 IDENTIFICAZIONE COMANDI
10/1
Nella parte superiore dell'impugnature è situata la zona co-
mandi del sollevatore; più precisamente:
1 - Pulsante di comando salita (fig.11/1 pos.1)
se premuto consente il passaggio di aria al sistema di
sollevamento costituito dalla membrana di gomma e
quindi la salita/estensione in verticale della stessa.
2 - Pulsante di comando discesa (fig.11/1 pos.2)
se premuto consente l'espulsione di aria dal sistema
3
interno di sollevamento costituito dalla membrana in
2
gomma e quindi la discesa/decompressione della stes-
sa.
11/1
3 - Pulsante di comando depressione (fig.11/1 pos.3)
se premuto insieme al pulsante di discesa (pos.2) aziona
il sistema a depressione che consente di richiudere com-
pletamente la membrana di sollevamento.
10
SIGNS AND WARNING
Comply with the warnings given by the signs; failure to do
so may cause injury.
WARNING:
Unreadable and missing warning
labels must be replaced immediately.
Do not use the jack if one or more
labels are missing.
Do not add any object that could
prevent the operator from seeing the
labels.
Use the code in this table to order
labels you need.
11
IDENTIFICATION OF CONTROL
The jack control zone is in the top of the handle, and
comprises:
1 - Lifting button (1 fig.11/1)
pressed to deliver air to the lifting system (rubber
diaphragm), pushing the system upward.
2 - Lowering button (2 fig.11/1)
pressed to expel air from the internal lifting system
(rubber diaphragm), decompressing it and lowering the
jack.
3 - Vacuum button (3 fig.11/1)
pressed together with the lowering button (2) it activates
the vacuum system which completely retracts the lifting
diaphragm.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

J1pJ1mpJ2J2pJ2mpJ3 ... Afficher tout

Table des Matières