Submerging The Pump - Grizzly TRP 350 K Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
Screwing together the alumini-
um tubes:
2. Screw together the tubes in the
following order:
- Bottom aluminium
tube (13) (without
rib),
- Middle aluminium
tube (14) (with 1 rib),
- Aluminium tube
with plastic hook
(15) (with 2 ribs),
- Flexible tube (20).
3. Mount the tubes onto the pump
pressure connection (2).
If necessary, use a suitable tool to
pull the aluminium tube connecting
elements in order to prevent water
from leaking.
Securing the mains cable:
4. Secure the mains connection ca-
ble (12) to the cable clamp (19)
on the plastic hook (22) and on
the middle aluminium tube (14).
Mounting the height adjust-
ment for the float switch:
5. Loosen the screw on the float
switch height adjustment (4) and
push this over the float switch
guide (5). Then guide the float
switch cable (3) upwards (see
also "Adjusting the float switch").
If you want to make use of the
maximum pumping capacity of the
pump rather than the maximum
discharge height, we recommend
that you fit a ¾ " connecting tube,
mounting it directly on the pump,
without aluminium tube or shut-off
tap. The larger cross-section of the
hose will enable a greater volume
of water to be pumped. At the same
time, the potential discharge height
will be correspondingly lower.

Submerging the pump

Ensure that the device is not hung
up or held by the mains cable.
There is a risk of electric shock
from damaged mains cables.
When submerging the pump, en-
sure that the shut-off tap (
is open, to guarantee that the air is
vented from the pump.
Use the plastic hook (
merging or lifting out the pump or fix a
cord to the pump carrying handle (
Do not hang the device directly by
the curved tube or on the water hose.
You can adjust the height of the plastic
hook after loosening the height-adjust-
ment screw (
When the water level is low, you can
also place the pump in the butt. If you
do, the shut-off tap must be above the
level of the edge of the container.
Note that over the course of time dirt
and sand which may damage the
pump will collect in the bottom of the
butt. We recommend standing the
pump on a brick.
GB
18)
22) for sub-
16).
1).
21

Publicité

Table des Matières
loading

Table des Matières