Spray Arms; Drain Pump - Thermador DWHD771W Série Manuel D'utilisation

Spray arms

Limescale and contaminants in the rinsing water may
block nozzles and bearings on the spray arms
and .
1J
Check outlet nozzles on the spray arms for blockages.
1.
Unscrew the upper spray arm
2.
downwards (2).
Remove the lower spray arm
3.
Clean spray arms under running water.
4.
Re-engage or screw on spray arms.
5.

Drain pump

Large food remnants in the rinsing water not retained by
the filters may block the waste water pump. In this case:
WARNING
9
Use caution when removing parts for cleaning as
some debris may be sharp.
Disconnect the appliance from the power supply.
1.
Take out upper rack
1"
2.
Remove the filters
1Z
3.
Scoop out standing water - use a sponge if necessary.
4.
Using a spoon, pry off the pump cover (as shown) until
5.
it clicks, then grip the cover and pull upward until it
resists and then pull forward (1). Remove cover
completely.
30
12
12 (1) and remove
1J upwards.
and lower rack .
1b
.
Check inner compartment and remove any foreign
6.
objects.
WARNING
9
Use caution when removing parts for cleaning as
some debris may be sharp.
Place pump cover in the original position (2) and
7.
press down until it engages (3).
Place cover in the original position, press down and
8.
engage.
Reinstall filters.
9.
Re-insert racks.
10.
Note: The drain pump will not work properly if the drain
pump cover is not snapped in completely until it clicks.