Zephyr Tempest I Guide D'utilisation page 26

Features & Controls
Touch Controls
Charcoal Filter Change Reminder (charcoal filter, if installed)
When your hood is installed as a recirculating unit, it is fitted with a set of charcoal
filters to purify exhaust and fumes from cooking, then re-circulates the air within the
home. These charcoal filters are required to be replaced after every 200 hours of use.
The charcoal filters should never be cleaned or placed in a dish washer.
The filter change reminder function in the microprocessor needs to be switched on.
When switched on, the microprocessor will elapse and count usage time and indicate
by a flashing
Setting the Filter Change Reminder
When off, hold
seconds. The display will change from
(exhaust mode) to
this indicates that the elapse timer function
is switched on and charcoal filters are used.
Filter Replace Indicator
When the display
charcoal filters need to be replaced.
Re-setting Function
Once filters are replaced, with hood off,
press and hold
hold for apprimately 5 seconds until
on displays disappears
change reminder is now re-set and a new
200 hour elapse cycle is initiated.
26
C
when charcoal filter replacements are needed.
for approximately 5
C
(recirculating mode)
C
starts flashing, the
the display will appear;
. The filter
Set Mode
hold 5 sec.
Change Filters Set Mode
To Reset
hold 5 sec.
C
Tempest I Use, Care, and Installation Guide
U N D E R - C A B I N E T
display from < - > to < C >
C
display < C > flashes
C
display from < C > to < >
C
P R O
T E M P E S T I