Littium BERLIN Manuel D'utilisation Et Garantie page 50

C.Turning the screen light on and off
By pressing the UP button, the screen will be switched on. By pressing the DOWN button for 3
seconds, its light will also be switched on.
This light will be switched off after pressing the DOWN button again for 3 seconds.
D. Choosing the PAS level
When the screen is on, you can click on the UP button to adjust the PAS level designed to change
the engine output power. The PAS level is normally set to level 0 and can be adjusted from 0 to 5.
E. Battery Indicator
If the battery is fully charged, 5 bars will be displayed on the screen as shown in the above picture.
These bars will gradually disappear as the charge depletes. When the battery is almost flat, the last
bar shown on the screen will start flickering, which means the battery needs to be charged again.
F. Error Code Definition
The E-Bike will stop working and the LCD display will show an error code upon a driving system
failure. This error will remain in the LCD display until solving the problem.
46