Personnel Qualifications; Danger In The Event Of Non-Observance Of The Safety Instructions; Safety Consciousness On The Job; Safety Instructions For The Operator - Resol PSW Basic Set Manuel

2.2

Personnel qualifications

The installation, operating and maintenance personnel must have the appropriate
qualifications for this work. Area of responsibility, terms of reference and monitor-
ing of the personnel have to be ensured by the operator. If the personnel are not
in possession of the necessary knowledge, they have to be trained and instructed.
This can be accomplished if necessary by the manufacturer of the product at the
request of the operator.
2.3

Danger in the event of non-observance of the safety instructions

Non-observance of the safety instructions can result in risk of injury to persons
and damage to the environment and the product/unit. Non-observance of the
safety instructions results in the loss of any claims to damages.
In detail, non-observance can, for example, result in the following risks:
• Danger to persons from electrical, mechanical and bacteriological influences,
• Damage to the environment due to leakage of hazardous materials,
• Property damage,
• Failure of important product/unit functions,
• Failure of required maintenance and repair procedures.
2.4

Safety consciousness on the job

The safety instructions included in this installation and operating instructions, the
existing national regulations for accident prevention together with any internal
working, operating and safety regulations of the operator are to be compliant with.
2.5

Safety instructions for the operator

This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, un-
less they have been given supervision or instruction concerning use of the appli-
ance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
• If hot or cold components on the product/the unit lead to hazards, local meas-
ures must be taken to guard them against touching.
• Guards protecting against touching moving components (such as the coupling)
must not be removed whilst the product is in operation.
• Leakages (e.g. from a shaft seal) of hazardous fluids (e.g. explosive, toxic or hot)
must be led away so that no danger to persons or to the environment arises.
National statutory provisions are to be complied with.
• Danger from electrical current must be eliminated. Local directives or general
directives [e.g. IEC, VDE etc.] and local energy supply companies must be ad-
hered to.
• Faults of electronic devices due to electromagnetic fields Electromagnet-
ic fields are created during the operation of pumps with frequency convert-
er. Interference of electronic devices may be the result. The result may be a
device malfunction, which can result in damage to the health or even death,
e.g. of persons carrying implanted active or passive medical devices.
Therefore, during operation the presence of any persons e.g. with cardiac pace-
makers in the vicinity of the unit/pump should be prohibited. With magnetic or
electronic data media, the loss of data is possible.
WARNING! Danger due to strong magnetic field!
Inside the machine there is always a strong magnetic field that can cause
injury and damage to property in the event of incorrect dismantling.
• It is only permitted to have the rotor removed from the motor housing by
qualified personnel!
• There is a crushing hazard! When pulling the rotor out of the motor, it may be
suddenly pulled back into its initial position by the strong magnetic field.
• If the unit consisting of impeller, bearing shield and rotor is pulled out of the
motor, persons with medical aids, such as cardiac pacemakers, insulin pumps,
hearing aids, implants or similar are at risk. Death, severe injury and damage to
property may be the result. For such persons, a professional medical assess-
ment is always necessary.
• Electronic devices may be impaired functionally or damaged by the strong
magnetic field of the rotor.
• If the rotor is outside the motor, magnetic objects may be attracted very
suddenly. That can result in injury and damage to property.
In assembled condition, the rotor's magnetic field is guided in the motor's iron
core. There is therefore no harmful magnetic field outside the machine.
23