GreenWorks ELITE EPW-2000 Guide D'utilisation page 12

ASSEMBLY INSTRUCTIONS
ASSEMBLING THE WHEELS
• Insert an axle (A) through a wheel (I), the axle sleeve (M), the frame of the unit and then a
washer (J).
• Insert a cotter pin (K) through the hole in the axle to secure. Repeat for second wheel.
A
ASSEMBLING THE FRONT PANEL AND GUN HOLDER
• Line up the screw sleeves with the holes in the upper handle and push through.
• Insert the screw and turn clockwise with a phillips head screw driver (not included) until the
screw is tight.
ASSEMBLING THE HOSE HOOK
• Line up the hose hook upper end with the holes on the back of the front panel
• Insert the hose hook end into the hole and push through.
• Press the hose hook lower end into the clip on the back of the front panel.
See Figure 3.
K
J
M
I
See Figure 4.
upper end
hole
lower end
clip
12
A
Fig. 3
See Figure 4.
Fig. 4