Refilling The Boiler; Setting The Temperature - Bosch sensixx B10L Mode D'emploi

6. The "Steam ready" indicator lamp (6) will light
up after approximately 7 minutes, indicating
that the appliance is ready to use.
7. If the "steam ready" lamp (6) lights and steam
is not released when pressing the steam
release button (11), refill the water tank.

1. refilling the boiler


See the leaflet sides
E
attention! risk of burns!
Be careful when opening the cap, steam
may escape.
1. Press the steam button (11) to check that no
more steam is generated. Only then the boiler
should be refilled.
2. Set the appliance switch (8) to the off position
("0") and unplug the steam station from the
mains. Then wait for minimal 2 minutes.
3. Open the cap (1) carefully and slowly. Allow
remaining steam to escape.
4. Refill the boiler using always the funnel (15).
Do not overfill the boiler.
5. If there is water left around the filling inlet,
please dry with a towel before closing the
boiler.
6. Close the cap firmly.
Important:
• Normal tap water can be used.
To prolong the optimum steam function, mix tap
water with distilled water 1:1. If the tap water in
your district is very hard, mix tap water with
distilled water 1:2.
You can inquire about the water hardness with
your local water supplier.
• To avoid damage and/or contamination of the
boiler, do not use perfumed water, vinegar,
starch, descaling agents, additives or any other
type of chemical product.
any damage caused by the use of the
aforementioned products, will make the
guarantee void.
• The iron is not designed to rest on its heal.
Please always position it horizontally on the
iron pad (2).
model dependent:
The iron pad can be placed into the specially
designed recess on the appliance or
somewhere suitable alongside the ironing area.
Never rest the iron on the appliance without
the iron pad!.
• During it first use the iron may produce certain
vapours and odours, along with white particles
on the soleplate, this is normal and it will stop
after a few minutes
14
B O SC H

2. Setting the temperature


See the leaflet sides
1. Check the ironing instruction label on the
garment to determine the correct ironing
temperature.
2. Turn the temperature selector (10) to the
required setting:
•
Synthetics
••
Silk – Wool
•••
Cotton – Linen
3. The indicator lamp (12) will remain lit while the
iron is heating and go out as soon as the iron
has reached the selected temperature.
Tips:
• Sort your garments out based on their cleaning
symbol labels, always starting with clothes that
have to be ironed at the lowest temperatures.
• If you are not sure what the garment is made of
then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn.
3. Ironing with steam

See the leaflet sides
1. Turn the temperature selector (10) to the
required setting
2. Press the steam release button (11) to release
steam.
attention:
• When ironing on a lower temperature setting
"•", only press the steam release button (11) for
a few seconds at a time.
If you find that water is dripping out of the
soleplate, set the temperature to a higher
position (take care that the garment can be
ironed on this heat temperature setting).
• At the beginning of each use, it is possible that
drops of water will be dispensed alongside steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
Tip: for better ironing results, iron the last strokes
without steam to dry the garment.