LG WT7250C Série Manuel D'utilisation page 46

46 TROUBLESHOOTING
Performance
Problem
Wrinkling
Staining
Poor stain removal
Musty or mildewy
odor in the washer
Washer is not unloaded promptly.
• Always remove items from the washer as soon as the cycle is complete.
Washer is overloaded.
• The washer can be fully loaded, but the tub should not be tightly packed with items. The lid
of the washer should close easily.
Hot and cold water inlet hoses are reversed.
• Hot water rinse can set wrinkles in garments. Check the Inlet hose connectors.
Bleach or softener dispensed too soon.
• Dispenser compartment was overfilled, causing the bleach or softener to dispense
immediately. Always measure bleach, and never use more than 1 cup.
Bleach or softener was added directly to the wash load in the tub.
• Always use the dispensers to ensure that laundry products are properly dispensed at the
right time in the cycle.
Washer was not unloaded promptly.
• Always remove items from the washer as soon as possible after the cycle is completed.
Clothes were not properly sorted.
• Always wash dark colors separately from light colors and whites to prevent discoloration.
• Never wash heavily soiled items with lightly soiled items.
Proper options are not selected.
• Heavier soils and tougher stains may require extra cleaning power. Select the Soak or
Stain Care feature to boost the cleaning power of the selected cycle.
Previously set stains.
• Articles that have previously been washed may have stains that have been set. These
stains may be difficult to remove and may require hand washing or pre-treating to aid in
stain removal.
Incorrect or too much detergent has been used.
• Use only HE (High-Efficiency) detergent in accordance with the manufacturer's
instructions.
Inside of the tub was not cleaned properly.
• Run the Tub Clean cycle regularly.
Possible Cause & Solution