Husky L210VWD Guide D'utilisation Et D'entretien page 16

Operation (continued)
4
Running the air compressor
WARNING: Always ensure the switch is in the OFF
position and regulator pressure gauge reads zero before
changing air tools or disconnecting the hose from the air
outlet. Failure to do so could result in possible serious
personal injury.
WARNING: Your tool may require more air consumption
than this air compressor is capable of providing. Check the
tool manual to avoid damage to the tool or risk
personal injury.
NOTE: Always use the minimum amount of air flow with
the pressure regulator knob. Using a higher pressure than
needed will drain air from the tank more rapidly and cause
the unit to cycle on more frequently.
□
Rotate the pressure regulator knob (7) to
the desired line pressure. Turning the knob
clockwise (+) increases air pressure at the
outlet; turning counterclockwise (-) reduces air
pressure at the outlet.
□
If using an inflation accessory, control the
amount of air flow with the pressure regulator
knob (7). Turning the knob fully counterclockwise
will completely stop the flow of air.
□
When finished, always drain the tank and unplug
the unit. Never leave the unit plugged in and/or
running unattended.
16
7