Attaching The Hose - Husky L210VWD Guide D'utilisation Et D'entretien

Pre-Operation (continued)

ATTACHING THE HOSE

WARNING: Do not attempt to modify this product or create
accessories not recommended for use with this product. Any such
alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING: Do not attach the air chuck or other tools to the open
end of the hose until start-up has been completed.
WARNING: Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is sufficient
to inflict serious injury.
WARNING: Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so could result
in objects being thrown into your eyes resulting in possible serious
injury.
The compressor is assembled at the factory and ready for
use. Check all components to ensure secure assembly, (such
as rubber feet, handle, quick connects, gages, safety valve,
air filter, drain valve, etc.)
□
Make sure the power to the air compressor is
disconnected.
□
Apply thread tape to the threaded connections of the
hose (not included), and attach the quick connect to the
hose using a wrench (not included).
□
Rotate the pressure regulator knob (7) fully
counterclockwise.
□
Insert the hose adapter end of the air hose (8) into the
female coupler end in the air compressor (9).
9
12
7
8