Clean Intake Housing; Charcoal Filter Replacement; Cleaning Agents - Bosch HDD80051UC Manuel D'utilisation Et D'entretien

In the dishwasher:
NOTE: Slight discoloration is possible when cleaning the
grease fi lters in the dishwasher. This is normal and does
not affect the performance of the grease fi lters.
•
Do not clean extremely dirty grease fi lters with
dishes.
•
Loosely position the grease fi lters in the top rack of the
dishwasher. Wash the fi lters through on Normal cycle.
The grease fi lters must not be jammed in.
Replace fi lters and front panel before using downdraft.
Make sure that the fi lters are seated properly.
To replace the front panel, align the brackets at the
bottom and pivot the panel inwards until it sits in place or
the TABS are engaged.
CAUTION
Failure to engage tabs properly may cause
chimney to jam and fail to raise up.
By hand:
NOTE: You can use a degreaser if soiling is stubborn.
You can order it via the online shop.
•
Soak the grease fi lters in warm soapy water for
10-15 minutes using a mild detergent.
•
Use a brush for cleaning and then rinse the fi lters
well.
•
Allow the grease fi lters to drip dry completely before
placing them back into the downdraft.
Clean and dry intake housing, then reinstall or replace
fi lters before using downdraft.

Clean Intake Housing:

•
Pull front panel up and out.
•
Remove both fi lters.
•
Use a mild detergent. DO NOT USE ABRASIVE
CLOTH, STEEL WOOL PADS, OR SCOURING
POWDERS.
•
Clean and reinstall or replace both fi lters and install
front panel before using downdraft.
NOTICE: The use of brand names is intended only to
indicate a type of cleaner. This does not constitute an
endorsement. The omission of any brand name cleaner
does not imply its adequacy or inadequacy. Many
products are regional in distribution and can be found
in the local markets. It is imperative that all products
be used in strict accordance with instructions on the
package.
NOTE: Do not use cooktop while hood is disassembled.

Charcoal Filter Replacement

It is recommended that you replace the recirculation fi lter
every 6 months. However, this may vary, depending upon
the type and amount of cooking you do.
To change the charcoal fi lter, remove the decorative cover
plate (on toe kick or base of the cabinet) and replace the
charcoal fi lter by a new one, part number HDDFILTUC.
Reinstall the decorative cover plate.

Cleaning Agents

To prevent various surfaces from becoming damaged
due to incorrect cleaning agents, follow the specifi cations
given in the table. Do not use:
•
cleaning agents that are harsh or scouring,
•
cleaning agents with high alcohol content,
•
hard scouring pads or sponges,
•
high-pressure cleaners or steam cleaners.
Rub stainless steel fi nishes in the direction of the grain.
Wipe area dry to avoid water marks.
After cleaning, place all parts in their proper positions
before using.
Thoroughly rinse all new sponges before use.
Observe all instructions and warnings accompanying
cleaning agents.
Area Cleaning agents
Stainless steel Warm soapy water:
Clean with a dish rag and dry with a
soft towel.
Only clean stainless steel with the
grain.
Specifi c products for stainless steel
care are available from customer
service or from specialized retailers.
Apply a thin layer of the care product
with a soft cloth.
Varnished Warm soapy water:
surfaces Clean with a damp dish rag and dry
with a soft towel.
Do not use stainless steel cleaner.
Aluminum and Glass cleaner:
plastic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Controls Warm soapy water:
Clean with a damp dish rag and dry
with a soft towel.
Risk of damage to electronics due
to moisture penetration. Never clean
controls with a wet cloth.
Do not use stainless steel cleaner.
11