Kenwood KTC-500DAB Mode D'emploi page 23

I can't connect my Bluetooth is switched off on your mobile
KTC-500DAB to a device.
compatible mobile device.
Another Bluetooth device is connected to
your KTC-500DAB.
Your KTC-500DAB isn't paired correctly
with your mobile device.
The wireless controller is The batteries in the controller are dead.
unresponsive or the screen is
The software has stopped working.
blank.
* To perform a power reset, use a paperclip to press and hold the reset button on the antenna for 10 seconds.
Check that your mobile device is Bluetooth compatible and Bluetooth is
switched on.
Switch off Bluetooth on the other device.
Pair your KTC-500DAB with your mobile device again. Read more on
page 14.
Replace the batteries in the controller.
Remove and then reinsert the batteries in the controller.
21