Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Step 8: Assembling the solar panel holder
Assemble the solar panel holder as shown on the drawing,
using the 2 pcs M3 x 8 screws and 2 pcs M3 nuts.
Screw M3 x 8
2 pcs.
Step 10: Installing the battery clips
Install the 4 battery clips as shown on the drawing.
Battery clip
4 pcs.
Step 11: Solar panel operation
Switch
1.5 Volt
Motor
Solar panel
FIRST PUT A PIECE OF ABOUT 1 CM TUBE AROUND THE WIRE!
a.
Push the unisolated wire through the hole of the solar panel connectors and
wrap it around 2 or 3 times (see small detail drawing).
b.
Connect the 25 cm blue wire from the switch to the + of the solar panel.
c.
Connect the blue motor wire to the - of the solar panel.
d.
Push the tube over the solar panel connectors so the tube will fix the wire
properly.
The solar panel operation will only succeed in very bright SUN or LAMP light!
Solar panel holder
Lock nut M3
2 pcs
Assemble the wires
as shown on the
drawing.
Electronic circuit diagram
Step 9: Installing the solar panel
Install the solar panel as shown on the drawing.
Solar panel
Note!
Push and CLICK the solar panel in the holder
The completed solar car !!!
Now you can put
the stickers on your
Solar Car.
See the packaging
for design ideas.
CLICK
CLICK
Publicité
Table des Matières
