Important; Necessary Tools; General Assembly Information - Arexx SOLAR E CAR Mode D'emploi

English
Parts list & Assembly instructions SOLAR E-CAR

Important!

Before you start with the construction of this kit, please identify each part using the diagram in step A.
Then read the entire set of instructions before you start with the assembly.
Motor (wired)
Motor pinion
1 pc.
1 pc.
Switch lever
1 pc. (Metal)
Sticker set
Gear shaft
1 pc.
1 pc. (Back wheel)

Necessary tools

Philips
screwdriver
Wrench
M2 / M3
Flatnose
plier
Cutter
Screw M3 x 8
5 pcs.
Switch mount
2 pcs. (Metal)
Wire, blue color 8 pc. 25 cm
Miniature light bulb 1 pc.
Chassis
Solar panel holder
1 pc. (Plastic)
1 pc. (Plastic)

GENERAL ASSEMBLY INFORMATION

Self-tapping screws (Parker)
A self-tapping screw looks similar to a wood screw.
When you screw it in a hole, it cuts the threads at the same time.
Never try to screw it down all the way for a first time,
because it may easily become stuck or you will damage its head.
Do not screw a tapping screw in and out too often because the screw hole may become enlarged and the screw will loose all
grip and proper function.
Screws and nuts
Length
The size of a screw is expressed by thickness and length.
A screw with the marking M2 x 10 means 2 mm thick.
The length of the thread is 10 mm. An M2 nut is used for an
M2 screw so the nut always corresponds with the screw thickness.
Tappingscrew
Screw M3 x 20
M2.3 x 8
1 pc.
2 pcs.
Panel mount support
2 pcs. (Plastic)
Gear shaft holder
1 pc. (Plastic)
Wheel shaft
1 pc. (Front wheel)
Solar panel
1 pc. (1.5V/350mA)
Wrench
This kit includes a small wrench.
Thickness
Please use this wrench to fit the M2
and M3 nuts in a proper way.
You can use it instead of a plier.
Nut M3
Lock nut
2 pcs.
4 pcs.
Silicon tube
1 pcs. (80mm)
Battery clips
4 pcs. (Metal)
Motor holder
1 pc. (Plastic)
Wheel
4 pcs. (Plastic)
This is the
proper way
to fasten
a lock nut