Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Step 1: Installing the wheel shaft with crown gear
Assemble the back wheel shaft as shown on the drawing. In this step you
need the Chassis, 2 pcs. M2.3 x 8 tapping screws, metal wheel shaft with
crown gear and the wheel shaft holder.
Wheel shaft with crown gear
Chassis
Step 3: Installing the front wheels
Assemble the front wheels as shown on the drawing,
using the 2 pcs. wheels and the metal wheel shaft.
1.
Push the first wheel onto the end of the shaft
2.
Put the shaft into the shaft holder of the chassis
3.
Put the second wheel onto the shaft
NOTE!
Assemble the front wheels exactly as shown on the drawing
Step 4: Assembling the on/off switch
Assemble the motor as shown on the drawing. In this step you
need; 1 pc. wired motor, 2 pcs. Switch mount, 2 pcs. M3x 8 screw,
2 pcs. nut and 1 piece of blue wire.
a.
The detailed drawing shows how to turn the wire around the M3
screws. Wrap it around 2 or 3 times (see drawing).
b.
One of the blue wires of the motor will be connected with the
screw of the switch.
c.
The separate 25 cm blue wire will be connected with the other
screw of the switch.
Note!
In step 6 you can see how to make a wire spiral
Tapping screw M2.3 x 8
2 pcs.
Wheel shaft holder
Note!
Before you start with the wiring,
you always must remove about
2 cm of the plastic insulation.
Step 2: Installing the back wheels
Push the 2 pcs. back wheels on the wheel shaft
Assembly of a wheel to an ax
Hit slightly with a small plastic hammer,
OR BETTER:
Push the wheel on the shaft with your hands.
Wheel
2 pcs.
Wheel
2 pcs.
Wheel shaft
Detail of motor wire connection
Screw M3 x 8
2 pcs.
Blue motor wire
Blue wire
Switch mount
2 pcs.
Nut M3
2 pcs.
Publicité
Table des Matières
