Inserting The Batteries In The Remote Control - ohmex MIST FAN 4040 WTR Manuel D'utilisation

FAN 4040 WTR
PREPARING THE APPLIANCE
There is a white, silicone ring, which MUST NOT be loosened when the water
container (18) is filled.
e. Re-position the water container (18) on the mister supply base.
f. Connect the plug to the current outlet (make sure that the network data correspond
with those present on the appliance data plate).
A "beep" indicates that the appliance is powered electrically and the luminous
"POWER" indicator on the main control panel switches on.
g. In this condition, the misting function can be activated from the control panel (9)
and via remote control (13). The MIST fan can now be activated on its own control
panel, on the main control panel and via remote control.
h. Press the ON key to switch the fan and mister unit on.
i. By default the appliance starts in the following way:
• Minimum speed
• Fixed direction (no swing)
• "Normal" wind mode
l. When the mister has been started, the speed and wind mode can be selected.
> > Inserting the batteries in the remote control
The appliance is equipped with a remote control.
To insert or replace the batteries:
1. R emove the battery slot cover from the remote control rear part.
2. I nsert the batteries (CR2025 type).
RESPECT THE POLARITIES!
3. Reposition the battery slot cover.
1 2 3
EN
63