Inserting The Batteries In The Remote Control; Remote Control Range - ohmex 1886 R Manuel D'utilisation

FAN 1886 R
PREPARING THE APPLIANCE
Installation of base (Fig. F3)
Put the connecting rod of fan downwards vertically, inset it into the position of "main
shaftbase", put the M6 screw through the screw hole at the base center and then tighten
the screw in clockwise direction with M6 wrench.
Installation of power cord (Fig. F4)
1. Insert the "8-shape power line" port into the 8-shape socket of product base.
2. Insert the power plug at the other end into socket; the power is on when there is a
"beep" sound.
Installation of fan head (Fig. F5)
1. Insert "fan head" (as per corresponding limit switch) into "connecting rod".
2. Tighten "nut of main rod" and finish installation of fan head after confirming that
there is no waggling of "fan head".
> > Inserting the batteries in the remote control
The appliance is equipped with a remote control.
To insert or replace the batteries:
1. Remove the battery slot cover from the remote control rear part.
2. Insert the batteries (CR2032 type).
RESPECT THE POLARITIES!
3. Reposition the battery slot cover.
If the remote control is not operated for prolonged periods of time, the
batteries will discharge and the remote control won't work; in this case,
replace the batteries with the new ones.
The remote control batteries must not be exposed to excessive heat such like
sun rays, flames or similar.
> > Remote control range
Do not submit the remote control to strong vibrations or shocks.
Store the remote control away from moisture and water.
EN
37