ohmex MIST FAN 4040 WTR Manuel D'utilisation page 66

EN
PREPARING THE APPLIANCE
l. Tighten the nut (2) in an ANTI-CLOCKWISE
direction to block the fan.
Check that the fan turns freely.
m.Open the fixing clips around the front grid and loosen the retainer screw in the
upper part of the front grid.
n. Position the upper clip onto the top part of the rear grid.
Push the upper clip downwards and press the edge of the front grid onto the
rear grid.
Close all of the fixing clips and tighten the safety screw.
o. Position the water tank on the mister supply base.
p. Connect one end of the pipe (15) to the water outlet unit (15) and the other end to
the cap (17) of the water container.
q. Position the cap (17) on the water container (18).
r. The appliance is ready for use.
> >Mister operation
a. Remove the water container (18) from the mister supply base.
Turn over to access a small plastic lid.
b. Open the small lid, by rotating it anti-clockwise.
c. Fill the container (18) with clean water.
d. Close the small lid correctly, by rotating it in a clockwise direction
62
2
FAN 4040 WTR