Glass Pane; Disassembly Of Glass Pane In Door; Assembly Of Glass Pane In Door; Disassembly Of Side Pane(S) - Dik Geurts Folke Instructions D'installation

9.2.4 Glass pane

• Prevent damage when removing/placing the glass pane.
!Caution
• Avoid/remove fingerprints on the glass pane(s) as they will burn into the glass.
Use the supplied glass pane cleaner to remove fingerprints from the glass pane(s).
!Tip

9.2.4.1 Disassembly of glass pane in door

To remove the glass pane in the door, please follow the instructions below (see appendix 2, fig. 19):
Ø
Open the door.
Ø
Lift out the door by sliding it upwards.
Ø
Place the door on a flat surface.
Ø
Unscrew the nuts on the inside of the door.
Ø
Remove the 4 glass strips and the tape of the door seal.
Ø
Lift the glass pane out. The pane seal is also taken out.

9.2.4.2. Assembly of glass pane in door

Mount the glass pane in the door in accordance with the steps described in section 9.2.4.1. 'Disassembly of glass
pane in door', only in reverse order.
• Do not fasten the nuts too tightly to avoid breaking off and/or stripping: overtightening will cause breakage.
!Caution
• Place the glass pane (including new pane seal) with the logo to the bottom right.
• Place a new door seal (see section 9.2.3.2).
• Attach both ends of the tape to each other at the bottom of the door with heat-resistant tape.
Make sure this connection of heat resistant tape is placed at the bottom of the glass pane.
!Caution

9.2.4.3 Disassembly of side pane(s)

Proceed as follows in order to remove the side pane(s) (see appendix 2, fig. 21):
Ø
Slightly lift the cover plate on top of the appliance or remove the cover plate.
Ø
Remove the side panel (left and/or right) by loosening and removing the 4 bolts.
Ø
Remove the glass clips.
• Stop the glass pane, before you remove the last glass clip.
!Caution
• When replacing the side pane(s), the glass pane seal must also be replaced.
Ø
Remove the glass pane. Here, the pane seal is also removed.

9.2.4.4 Assembly of side pane(s)

Mount the side pane(s) by observing the steps in section 9.4.3 in reverse order.
45