Makita LS0714 Manuel D'instructions page 22

In the case of left bevel cut
Table (A)
Molding position
in Fig. 41 & 42
For inside corner
For outside corner
006361
Table (B)
Molding position
in Fig. 41 & 42
For inside corner
For outside corner
006362
Example:
In the case of cutting 52/38° type crown molding for position (1) in Fig. 41 & 42:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6° RIGHT.
• Lay crown molding with its broad back (hidden) surface down on the turn base with its CEILING CONTACT EDGE
against the guide fence on the saw.
• The finished piece to be used will always be on the LEFT side of the blade after the cut has been made.
In the case of right bevel cut
Table (A)
Molding position
in Fig. 41 & 42
For inside corner
For outside corner
006363
Table (B)
Molding position
in Fig. 41 & 42
For inside corner
For outside corner
006364
22
52/38° type
(1)
(2)
Left 33.9°
(3)
(4)
Molding edge against guide fence
Ceiling contact edge should be
(1)
against guide fence.
(2)
Wall contact edge should be against
guide fence.
(3)
Ceiling contact edge should be
(4)
against guide fence.
52/38° type
(1)
(2)
Right 33.9°
(3)
(4)
Molding edge against guide fence
Wall contact edge should be against
(1)
guide fence.
(2)
Ceiling contact edge should be
against guide fence.
(3)
Wall contact edge should be against
(4)
guide fence.
Bevel angle
45° type
Left 30°
Bevel angle
45° type
Right 30°
Miter angle
52/38° type 45° type
Right 31.6° Right 35.3°
Left 31.6° Left 35.3°
Right 31.6° Right 35.3°
Finished piece
Finished piece will be on the Left
side of blade.
Finished piece will be on the Right
side of blade.
Miter angle
52/38° type 45° type
Right 31.6° Right 35.3°
Left 31.6° Left 35.3°
Right 31.6° Right 35.3°
Finished piece
Finished piece will be on the Right
side of blade.
Finished piece will be on the Left
side of blade.