Important - DeWalt DW006 Guide D'utilisation

outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician
to install a polarized outlet. Do not change
the plug in any way. Double insulation
eliminates the need for the three wire
grounded power cord and grounded power
supply system. Applicable only to Class II (double insulated)
tools.
• Avoid body contact with grounded surfaces such as pipes,
radiators, ranges and refrigerators. There is an increased risk of
electric shock if your body is grounded.
• Don't expose power tools to rain or wet conditions. Water
entering a power tool will increase the risk of electric shock.
• Do not abuse the cord. Never use the cord to carry the tools
or pull the plug from an outlet. Keep cord away from heat, oil,
sharp edges or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk of electric shock.
• When operating a power tool outside, use an outdoor
extension cord marked "W-A" or "W." These cords are rated for
outdoor use and reduce the risk of electric shock.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft. 50 ft. 75 ft. 100 ft.
7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m
Wire Size AWG
18 18 16 16
• Avoid accidental starting. Be sure switch is off before plugging
in. Carrying tools with your finger on the switch or plugging in tools
that have the switch on invites accidents.
• Disconnect the plug from the power source before making any
adjustments, changing accessories, or storing the tool. Such
preventative safety measures reduce the risk of starting the tool
accidentally.
• The label on your tool may include the following symbols. The
Installing and Removing the Battery
(Fig. 1)
NOTE: Make sure your battery pack is fully
charged. To install the battery pack into the tool
handle, align the base of the tool with the notch
inside the tool's handle and slide the battery
pack firmly into the handle until you hear the
lock snap into place as shown in FIG. 1.
To remove the battery pack from the tool, press
the release buttons and firmly pull the battery
125 ft. 150 ft. 175 ft.
pack out of the tool handle. Insert it into the
53.3 m
charger as described in the charger section of
this manual.
14 14 12

Important!

This product is not user serviceable. There are no user serviceable
parts inside the charger. Servicing at an authorized service center is
required to avoid damage to static sensitive internal components.
READ ALL OF THE INSTRUCTIONS IN THE BATTERY CHARGER
SECTION OF THIS MANUAL BEFORE ATTEMPTING TO CHARGE
THE BATTERY PACK FOR YOUR TOOL.
6
symbols and their definitions are as follows:
V ..............volts
Hz ............hertz
min ............minutes
..........direct current
.............. Class II Construction
............safety alert symbol
..................
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
A ............amperes
W ..........watts
..........alternating current
n o ..........no load speed
.......... earthing terminal
.../min ....revolutions per
..............minute
FIG. 1
B
A