Hewi PS160XA10 Notice De Montage page 10

Panic bar PS160XA/PS111XA
Important information
Mounting side - Handle with handlebar
Schlossseite
Lock side
= Griffrohr
= handlebar
Important!
1
Always mount the handlebar on the lock side
Conforms to CE up to BA 1580 mm
2
10 | HEWI
Warnings and cautions
The panic bar may only be used for the intended pur-
pose according to DIN EN 1125.
It is not permitted to shorten the bar.
It is not permitted to use the bar as a ladder or climbing
aid.
The panic bar may not be secured with chains or any
other means against accidental opening.
Do not push beds or any other objects against the bar.
Damage due to vandalism results in loss of warranty.
The different door widths are covered in defined ex-
tendable steps (see Page 8 Item numbers). Check the
extension of the angle lever. The handle must plunge
at least 20 mm into the grab handle tubing by (see left-
hand Figure 1).
The short angle lever with the handlebar of the handle
must always be mounted on the lock side (see left-hand-
Figure 2).
Conforms to CE up to BA 1580 mm only, door width ca.
1600 mm (see left-hand Figure 3).